Marilee
04-21-2002, 04:12 PM
If you just have a small hole or tear in a screen, fix it! Step 1: Try weaving the screen back together with a long needle. Step 2: Once the pieces are back in place, paint both sides with clear nail polish.
1: For a larger hole, you can patch it with another piece of screen.
2: Cut a piece of new screen about an inch larger than the hole. Pull a few strands of screen out so you’re left with a patch taht you can weave into the screen.
If you have a worn and tattered screen, replace it! It’s easy to do.
1: Pry part of the old spline out with an awl or screwdriver (Spline is a thin rubber rope that holds the screen in the frame). Pull the entire spline out of the frame.
2: Remove the Screen
3: Lay the new screening out over the frame and trim it back so you have an extra inch on all four sides.
4: Use grip clamps to hold the screen on one side.
5: On the edge opposite the clamps, pull the screen taut and use a spline roller to push new spline into the frame. Continue until all sides are finished.
6: Use a screwdriver to gently push the spline securely into the corners of the frame.
7: Trim away any excess with a sharp utility knife.
1: For a larger hole, you can patch it with another piece of screen.
2: Cut a piece of new screen about an inch larger than the hole. Pull a few strands of screen out so you’re left with a patch taht you can weave into the screen.
If you have a worn and tattered screen, replace it! It’s easy to do.
1: Pry part of the old spline out with an awl or screwdriver (Spline is a thin rubber rope that holds the screen in the frame). Pull the entire spline out of the frame.
2: Remove the Screen
3: Lay the new screening out over the frame and trim it back so you have an extra inch on all four sides.
4: Use grip clamps to hold the screen on one side.
5: On the edge opposite the clamps, pull the screen taut and use a spline roller to push new spline into the frame. Continue until all sides are finished.
6: Use a screwdriver to gently push the spline securely into the corners of the frame.
7: Trim away any excess with a sharp utility knife.